DIY Cad

These are the basic drawings for de DIY model. The snap-connections still need to be drawn. Then we can proceed to make the Lasercut drawings and make the prototype.

Tool plate:
On the plate we will place the tools. This is the large version. There is also a smaller version which is half the length. (20cm)

The snap-connections will be on the side.

The crosses are 25 mm apart. in these crosses come another part, the sliders. On the sliders we will connect a flexible piece of fabric. This fabric will hold the tool and the Sliders will press the fabric against the back of the plate.

The handle part is a more difficult part so we still need to optimize the design.